3M 800ab User Manual

17 

2010 December

800ab-NA 

A tool kit containing some tools are supplied 
with the machine. These tools should be 
adequate to set-up the machine, however, 
other tools supplied by the customer will be 
required for machine maintenance.

Adjust machine bed height. The case sealer is 

equipped with four (4) adjustable legs that are 

located at the corners of the machine frame. The 

legs can be adjusted to obtain different machine bed 

heights from 610mm [24 inches] minimum to 890mm 
[35 inches] maximum - See Specifi cations.

Refer to Figure 7-3 and set the machine bed height 

as follows:

1.  Raise and block up the machine frame to allow 

 

adequate leg adjustment.

2.  Loosen, but do not remove, two (2) M8 x 16mm

 

socket head screws in one leg (use M6 hex 

 

wrench). Adjust the leg length for the desired 

 

machine bed height. Retighten the two screws 

 

to secure the leg. Adjust all four (4) legs equally.

The machine should operate in a dry and relatively
clean environment (See Specifi cations).

Minimum distance from wall (Figure 7-1):

A =  1000mm.
B  =    700mm.
Minimum height = 2700mm.

•  To reduce the risk associated with 

−  Allow only properly trained and 

 qualifi ed personnel to operate and service 
 this 

equipment.

• 

− 

Use the appropriate rigging and 

 

material handling equipment when 

 

lifting or repositioning this equipment.

 − 

Use proper body mechanics when 

 

removing or installing taping heads 

 

that are moderately heavy or may be 

 

considered awkward to lift.