MGE UPS Systems 3000 RT 2U User Manual

34007776EN/AB

 - Page 23

6. Appendices

6.2 Glossary

  

Bypass line from the AC-power source, controlled by the UPS, used to directly supply the load if 
an overload or a malfunction occurs on the UPS.

Time during which the load can be supplied by the UPS operating on battery power.

Internal UPS test to check battery status.

Devices connected to the UPS output.

Battery discharge beyond the permissible limit, resulting in irreversible damage to the battery.

Module with UPS outlets for installation in a bay. There are different modules with different types 
of outlets.

Operating mode used to convert the AC-power frequency between the UPS input and output 
(50 Hz -> 60 Hz or 60 Hz -> 50 Hz).

UPS manual-bypass module for maintenance. There are different modules with different types of 
outlets.

This is a battery-voltage level indicating that battery power is low and that the user must take 
action in light of the imminent break in the supply of power to the load.

The AC-power line supplying the UPS under normal conditions.

Ratio of the power effectively drawn by the load to the maximum output of the UPS.

It is possible to modify certain UPS parameters set in the factory. Certain UPS functions can also 
be modified by the Personal Solution-Pac software to better suit user needs.

These outlets can be automatically shut down during operation on battery power (shutdown time 
delays can be programmed with the Personal Solution Pac software). The UPS has two sets of 
two programmable outlets.

The devices connected to the UPS can be started even if AC power is not available. The UPS 
operates on battery power alone.

Uninterruptible Power System.

This function enables or disables initiation of UPS ON/OFF control sequences by computer 
power management software.