Eaton Electrical 9130 User Manual
INSTALLATION
Eaton
®
9130 UPS (700–3000 VA) User's Guide
S
164201718 Rev 2
www.powerware.com
30
Tower Wiring Installation
This section explains:
S
Installing the UPS, including connecting the UPS internal batteries
S
Connecting any optional EBMs
Installing the UPS
NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur to
your equipment and void your warranty.
your equipment and void your warranty.
NOTE Do not connect the UPS power cord to utility until after installation is completed.
To install the UPS:
1.
To remove the cover, push down on the top of the cover and pull
the cover toward you to unclip it from the cabinet.
the cover toward you to unclip it from the cabinet.
NOTE A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable
or disconnect it.
or disconnect it.
NOTE Leave
ribbon cable
connected.
ribbon cable
connected.
Figure 14. Removing the UPS Front Cover