Konica Minolta Di1610p User Manual
6.11 The machine is not functioning as designed
6
Di1610/Di1610p
6-29
W
he
n
a Mes
s
age Ap
pear
s
Ch
apt
er
6
6.11
The machine is not functioning as designed
* If the problem is not corrected even after the operations described are performed, turn off the machine,
unplug its power cord, and then contact the service representative.
Symptom
Possible Cause
Action
Nothing appears in the Display.
Is only the [Start] key lit green?
The Energy Save mode is
enabled. Press any key on the
Control Panel to cancel Energy
Save mode.
enabled. Press any key on the
Control Panel to cancel Energy
Save mode.
Has the machine been turned
on?
on?
Check that the power cord is
firmly connected and that the |
(on) side of the Power Switch
has been pressed.
firmly connected and that the |
(on) side of the Power Switch
has been pressed.
Is the contrast of the Display too
light?
light?
From the “MACHINE
SETTING” menu of the Utility
mode, adjust the Display to the
correct contrast. Refer to
“Specifying the Setting for “LCD
CONTRAST”” on page 5-9.
SETTING” menu of the Utility
mode, adjust the Display to the
correct contrast. Refer to
“Specifying the Setting for “LCD
CONTRAST”” on page 5-9.
The [Start] key indicator does not
light up green.
light up green.
The machine has just been
turned on and is warming up.
turned on and is warming up.
It takes the machine less than
25 seconds to be ready to make
copies after it has been turned
on.
Please wait.
25 seconds to be ready to make
copies after it has been turned
on.
Please wait.
The machine does not operate
when it is turned on.
when it is turned on.
The power cord is left
unplugged.
unplugged.
Plug the power cord into the
power outlet.
power outlet.
The room’s circuit breaker is
open.
open.
Close the room’s circuit
breaker.
breaker.