Benq W1060 User Manual
Operation
29
Eng
lish
lish
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time.
display one full screen at a time.
You can also manually cycle through the
available input signals.
available input signals.
1.
Press SOURCE on the projector or remote
control. A source selection bar displays.
control. A source selection bar displays.
2.
Press
/
until your desired signal is
selected and press MODE/ENTER.
Once detected, the selected source
information will display on the screen for
seconds. If there is multiple equipment
connected to the projector, repeat steps 1-2
to search for another signal.
Once detected, the selected source
information will display on the screen for
seconds. If there is multiple equipment
connected to the projector, repeat steps 1-2
to search for another signal.
•
The brightness level of the projected image
will change accordingly when you switch
between different input signals. Data (graphic)
"PC" presentations using mostly static
images are generally brighter than "Video"
using mostly moving images (movies).
will change accordingly when you switch
between different input signals. Data (graphic)
"PC" presentations using mostly static
images are generally brighter than "Video"
using mostly moving images (movies).
•
The native display resolution of this projector
is in a 16:9 aspect ratio. For best display
picture results, you should select and use an
input signal which outputs at this resolution. Any other resolutions will be scaled by the
projector depending upon the 'aspect ratio' setting, which may cause some image
distortion or loss of picture clarity. See
is in a 16:9 aspect ratio. For best display
picture results, you should select and use an
input signal which outputs at this resolution. Any other resolutions will be scaled by the
projector depending upon the 'aspect ratio' setting, which may cause some image
distortion or loss of picture clarity. See
for details.
Changing Color Space
In the unlikely event that you connect the projector to a DVD player via the projector’s
HDMI input and the projected picture displays wrong colors, please change the color space.
HDMI input and the projected picture displays wrong colors, please change the color space.
To do this:
1.
Press MENU/EXIT and then press
/
until the DISPLAY menu is highlighted.
2.
Press
to
highlight
Color Space Conversion and press
/
to select the setting.
This function is only available when the HDMI input jack is in use.
PC
COMPONENT
VIDEO
HDMI 2
HDMI 1
S-VIDEO