Intel 8205 User Manual

10

This section describes how to set up firewall filters

and NAT (network address translation) for servers on
your LAN, using the LAN 2 port setup wizard.
Create firewall filters for LAN users
For added security, you can enable firewall filtering

on the LAN 2 port. If you enable the firewall, then

you must choose which types of traffic to allow

through the firewall on the Internet connection. For

example, in order for LAN users to browse the Web,

you must enable the WWW firewall filter.

1 From Connection Setup dialog box, double-click

the LAN 2 port.

2  On the first wizard screen, click “Connect to the

Internet through a DSL modem”, and then click

Next.

3  Fill out the IP Address dialog box as appropriate

for your scenario, and then click Next.

4 Select the Enable Firewall Filters check box.
5  Select the check box corresponding to the types of

traffic to allow from the LAN to the Internet, and

then click Next.

Access internal servers from the Internet
If you have servers on the internal LAN that must be

accessible from the Internet (such as a mail server or

a WWW server), configure the LAN 2 port to

recognize these servers. The router automatically

creates NAT (Network Address Translation) map-

pings between the IP address the router receives from

the ISP and the internal address used for the servers.
1 Click the type of server to which the router should

allow access from the Internet.

2  Type the server IP address, which must be on the

same subnet as the address range assigned by your

DHCP server.

3  Click Next and follow the screen instructions.

Figure 17. Set up a firewall and filters.

Figure 18. Allow access to internal servers from the
Internet.

A43586-001.p65

10/24/00, 10:44 AM

10