Lucent Technologies MN102H75K User Manual
On-Screen Display
Standard and Extended Display Modes
Panasonic Semiconductor Development Company
MN102H75K/F75K/85K/F85K LSI User Manual
160
Panasonic
In standard mode, STC0 is the only cursor tile code register that is enabled. Use
the cursor horizontal position register (SHP, x’00F12’) and the cursor vertical
position register (SVP, x’007F14’) in both modes to program the display start
position register (SVP, x’007F14’) in both modes to program the display start
position. In extended mode, this position refers to the upper left corner of tile (1).
Set the color palette for each tile individually.
Set the color palette for each tile individually.
7.6.2
Graphics Layer Display Modes
The size of the tiles in the graphics layer is programmable to 16W x 16H pixels
in standard mode and 16W x 18H pixels in extended mode. Select the mode for
in standard mode and 16W x 18H pixels in extended mode. Select the mode for
this layer in the GTHT bit of the OSD2 register (x’007F08’).
You cannot use the tiles created
for graphics layer extended
for graphics layer extended
mode as cursor tiles.
In extended mode, the tiles are the same size as the characters in the text layer.
This allows for a cleaner display when text and graphics appear side by side.
Table 7-4 Associated Tiles for Cursor Tile Code Registers
Graphic Tile
Register
Register Address
(1) Upper left
STC0
x’007F10’
(2) Upper right
STC1
x’007F2A’
(3) Lower left
STC2
x’007F2C’
(4) Lower right
STC3
x’007F2E’
A. Standard Mode (16W x 16H)
B. Extended Mode (16W x 18H)
Figure 7-3 Graphic Tiles in Standard and Extended Modes
16 pixels
16
pixels
Display start position
set in GHP and GVP
set in GHP and GVP
16 pixels
18
pixels
Display start position
set in GHP and GVP
set in GHP and GVP