Monte Carlo Fan Company 5AYR54 Series User Manual

Loosen 2 screws with key slots and

remove the 1 screw without ket slot.

Save screw removed. 

Make wire connections to power source using

wire nuts provided.  Make sure that no filiments

are outside of the wirenut. After making the

wire connections, the wires should be spread

apart with the grounded conductor and the

equipment-grounding conductor on one side of

the outlet box and ungrounded conductor on

the other side of the outlet box.

Lift Canopy to ceiling aligning the key hole slots

with the screws on the bottom of the Mounting

bracket.  Rotate the canopy Counter Clockwise

to lock in place.  Tighten the screws to secure

the Canopy.  See inset for Keyhole shape

white

Red

Make wiring connections as indicated above.

White from fan to white from remote marked

N.  Orange from fan to Orange from remote

marked Light/up. Blue from fan to blue from

remote marked down light. Black from fan to

Red from remote marked L.  White from

house to white from remote marked AC N .

Black from house to Black from remote

marked AC  L. Connect all green ground wires

to Ground wire from House.

Install remote receiver by sliding into opening in

the Mounting bracket.  Make sure that the dip

switches on the Transmitter and the Receiver

are set to the same position.  See Fig 37 for

remote operation

orange

blue

Green

white
black

House

Fan

Check the motor for plastic shipping sta-

bilizer tabs and remove if they are pres-

ent. The screws, washers and motor pads

are pre-installed to the blade holders.

Attach blade assembly to motor and tight-

en screws securely.

Hang fan from mounting bracket.

Install keeper into cross pin.

Tighten 2 downrod set screws and

lock nuts.

Thread leadwires, safety cable, yoke

cover and canopy through downrod.

Set dip switches on the Remote Transmitter and

Remote Receiver to the same settings.  This must be

done so the units will communcate properly.  If you

have other fans you can set to control from one

transmitter by setting both receivers the same as the

transmitter.  If you have more than one fan with

remote.  You can set the dip switches to different

positiosns to have seperate control.

Remote Transmitter Dip swtiches

Remote Receiver Dip switches

Fan and light kit combinations over 35 lbs,

in both flush and downrod mode the safety

cable must be installed into the house struc-

ture beams using the 3” lag screws,washers,

and lock washers. provided.  Make sure that

when the safety cable is fully extended the

lead wires are longer than the cable and no

stress is placed on the lead wires. 

Safety cable installation

safety

cable

3” lag

screw

lock

washer

washer