Hitachi VM-3700A User Manual
USING THE BUILT-IN CAMERA LIGHT
68
• During operation and/or after use of the camera light, the front surface and lamp of the
camera light will be very hot. To avoid burns or hair damage, do not touch them with your
hand.
• When the camera light is on, do not allow water to drop on the light.
• When the camera light is on, avoid subjecting the camera light to impacts or sharp
vibrations.
• Do not allow the cooling vents to become blocked. Also, do not cover the camera light
with paper or other objects, since the air flow will be interrupted, resulting in possible
overheating hazard.
• Never use the camera light in the vicinity of explosive or highly inflammable materials.
• When storing the camera light in the camera case following use, be sure to allow it
sufficient time to fully cool down before placing it in the case.
• Replace only with the specified lamp (optional) to reduce the risk of fire.
camera light will be very hot. To avoid burns or hair damage, do not touch them with your
hand.
• When the camera light is on, do not allow water to drop on the light.
• When the camera light is on, avoid subjecting the camera light to impacts or sharp
vibrations.
• Do not allow the cooling vents to become blocked. Also, do not cover the camera light
with paper or other objects, since the air flow will be interrupted, resulting in possible
overheating hazard.
• Never use the camera light in the vicinity of explosive or highly inflammable materials.
• When storing the camera light in the camera case following use, be sure to allow it
sufficient time to fully cool down before placing it in the case.
• Replace only with the specified lamp (optional) to reduce the risk of fire.
To replace the lamp of camera light
To remove the front case, press and hold the tab, then remove the front case.
To replace the front case, pass the lamp through the hole of the reflection plate then
attach the upper hooks to the camera light, and then attach the lower hook to the
camera light.
camera light.
NOTES:
• Do not touch the lamp directly with your fingers. It may shorten its service life.
• When the lamp is replaced, or when the front case of the camera light is removed, make
sure the front case is attached to the camera light properly.
• Consult your nearest service center to replace the lamp.
• Do not touch the lamp directly with your fingers. It may shorten its service life.
• When the lamp is replaced, or when the front case of the camera light is removed, make
sure the front case is attached to the camera light properly.
• Consult your nearest service center to replace the lamp.