Hitachi VM-H725LA User Manual
General Maintenance
- 54 -
To prevent scratching, use a soft non abrasive cloth, swab or lens cleaning paper.
3. Fit the projection of the eye cup into the groove in the viewfinder and rotate the eye cup in the direction of the
arrow.
3. Fit the projection of the eye cup into the groove in the viewfinder and rotate the eye cup in the direction of the
arrow.
Periodic Maintenance
A precision electromechanical device, the Hitachi VM-H725LA/H825LA requires maintenance after a period of
normal use. We expect that no other maintenance other than head cleaning will be required during the period of
warranty unless the camcorder is used either heavily or seldom. Defective parts are covered by the warranty.
Normal maintenance is the responsibility of the owner. Consult your dealer or local VCR service center for
recommendations regarding normal maintenance based on your use patterns, location, and the age of the
camcorder.
normal use. We expect that no other maintenance other than head cleaning will be required during the period of
warranty unless the camcorder is used either heavily or seldom. Defective parts are covered by the warranty.
Normal maintenance is the responsibility of the owner. Consult your dealer or local VCR service center for
recommendations regarding normal maintenance based on your use patterns, location, and the age of the
camcorder.
Troubleshooting
Quality is very important at Hitachi. We inspect and check every camcorder carefully at the factory under the most
rigid quality control and inspection systems. If problems develop please check the following possible solutions
before inquiring about professional service.
rigid quality control and inspection systems. If problems develop please check the following possible solutions
before inquiring about professional service.
INSERTING OR REMOVING THE CASSETTE
Symptom
Check
Point
&
Correction
Cassette holder cannot be opened when you press
• Connect the power source
EJECT switch
Cassette cannot be inserted into cassette
Cassette cannot be inserted into cassette
• Load cassette in direction indicated by
arrow on
compartment
compartment
cassette
•
Cassette
window
must
be
toward
outside.
CAMERA RECORDING
Symptom
Check
Point
&
Correction
Picture does not appear in the viewfinder or LCD
• Remove the lens cap.
monitor.
• Slide the CAM/OFF/VIDEO switch to CAM.
• Disconnect the AV input cable from the the
camcorder.
The camcorder cannot go into the recording
• Check the record-protect tab on the
cassette.
mode, even when the start/stop button is pressed.
mode, even when the start/stop button is pressed.
See page 19 for details.
•
Push
the
cassette
holder
embossed
PUSH
LOCK to
close it.
•
Slide
the
CAM/OFF/VIDEO
switch
to
CAM.
Picture is out of focus.
• Make sure that FOCUS does not
appear in the
Auto-focus does not operate.
Auto-focus does not operate.
viewfinder or LCD monitor. If it is
displayed, press
FOCUS Control buttons to erase it.
•
Auto-Focus
does
not
operate
if
a
special-
effects
filter is attached or the objects shown on
page 39 are
being
recorded.