Indesit IDVA 735 S User Manual

GREEN &
YELLOW

BROWN

BLUE

13 ampere fuse

CROSS-BAR
CORD GRIP

Green and Yellow (Earth) 

wire to terminal marked “E”, 

symbol x, or coloured green 

and yellow.

Blue (Neutral) wire to 

terminal marked ”N” or 

coloured black.

13A ASTA approved fuse 

to BS 1362.

Brown (live) wire to 

teminal marked “L” or 

coloured red.

Before plugging the appliance into the socket, check the 
following: 
•  Make sure your hands are dry.
•  The socket must have an earth connection.
•  The socket must be able to withstand the machine’s ma-
ximum power output as indicated on the Rating plate (see 
Description of the tumble dryer).
•  The power supply voltage must fall within the values indicated 
on the Rating plate (see Description of the tumble dryer).

•  The socket must be compatible with the dryer’s plug. 

Should this not be the case, replace the plug or the socket. 

!

 Do not use extension cords. 

!

 The dryer must not be installed outdoors, even if the space 

is sheltered. It can be very dangerous if exposed to rain or 

storms. 

!

 Once installed, the dryer’s electrical wire and plug must be 

within reach. 

!

 The power cord must not be bent or squashed. 

!

 The power cord is supplied fitted with a BS1363 plug 

and with a 13 amp BS1362 fuse. If it is necessary to fit a 

replacement fuse, it must be a 13 Amp ASTA approved 

to BS1362 type. WARNING: The plug must not be used 

without a fuse cover. If a replacement fuse holder/cover is 

required, it must be of the same colour coding or wording as 

shown on the base of the plug. 

Replacements are available from authorised dealers.

Changing the plug  

The wires in the power cord are coloured in accordance with 

the following.

!

 If the plug being replaced is a non-rewirable type, then the 

cut-off plug must be disposed of safely. DO NOT leave it where 

it can be inserted into a socket and create a shock hazard.

!

 The power cord should be checked periodically and replaced 

by a cord specially prepared for this dryer and fitted only by 

authorized technicians (see Service). New or longer power 

cords are supplied at an extra charge by authorized dealers.

!

 The manufacturer denies any responsibility should any of 

these rules not be followed.

!

 If in doubt about any of the above consult a qualified 

electrician.

The tumble dryer should be installed level in order to 

operate correctly.

After installing the tumble 

dryer in its permanent 

position, make sure it is level; 

check its side-to-side levelling 

first, followed by front-to-

back. 

If the tumble dryer is not 

perfectly level, use a wooden 

block to support it while you 

adjust the two front feet, up or 

down as necessary.

Once the tumble dryer is installed, clean the inside of the 
drum before operating it and remove any dirt accumulated 
during transportation.