Alliance Laundry Systems Clothes Dryer User Manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

512686

24

The control enters Error Display Mode to display 

thermistor errors. The heater is turned off, the IN USE 

LED flashes to indicate the error (refer to paragraphs 

below), and the timer will continue to count down 

time. The control remains in Error Display Mode until 

the control senses the thermistor has returned to an 

acceptable heating range, the cycle ends or machine is 

powered down.

If the control senses a temperature less than 0

°

F when 

the heat has been on for at least three minutes it will 

set an open thermistor error. The control will flash the 

IN USE LED twice separated by a one and a half 

second pause. This sequence is repeated as long as the 

Open Thermistor error is sensed.

If the control senses a temperature greater than 210 ± 

4

°

F during an active cycle it will set a Shorted 

Thermistor error. The control will flash the IN USE 

LED three times separated by a one and a half second 

pause. This sequence is repeated as long as the Shorted 

Thermistor error is sensed.

To change the dry time on the dryer, combinations of 

dipswitches can be set on the control. Refer to 

Figure 25.
There are eight dipswitches on the dryer control. The 

first six switches are used to program the amount of 

additional heat time given for each coin pulse. The 

additional drying time is added to the factory default 

minimum heat time of one minute. A value of 1 to 63 

minutes of additional drying time is available for each 

coin slide pulse.

The last two switches are used to program the amount 

of additional cool down time. The additional cool 

down time is added to the factory default minimum 

cool down time of 3 minutes. A value of 1 to 3 

additional minutes is available.

The seventh switch is used to program the amount of 

additional cool down time. The additional cool down 

time is added to the factory default minimum cool 

down time of 3 minutes. A value of 3 additional 

minutes is available.
The eighth switch is used for the cycle reset. If the 

switch is OFF (default), the control will save the time 

left on a cycle in case of a power failure. If the switch 

is ON, the control will clear the cycle and return to 

Ready Mode if there is a power failure.

The control is shipped from the factory programmed 

with 1 minute of minimum heat time, preset with 41 

additional minutes of drying time (dipswitches 1, 4 

and 6 in ON position) and 3 minutes of minimum cool 

down time for a total time of 45 minutes for a coin 

pulse. Refer to Table 6 for dipswitch settings.
The control reads the dipswitch settings at power-up. 

The control must be powered down to change the 

dipswitch settings.
To change the heat or cool down time for a coin pulse, 

the desired dry time dipswitches must be set to ON 

position. All other dipswitches must be in OFF 

position.

Models Starting Serial No. 0909
Resetting Cycle Time to Zero

To remove any cycle time that may have accumulated 

on the control during setup, the cycle time on the 

control can be reset to zero. 
To reset the time, unplug the dryer and set dipswitch 8 

to ON position. Restore power to the dryer for 10 

seconds and once again unplug dryer. Set dipswitch 8 

to OFF position and restore power to the dryer.