Sportline 345 User Manual

BUTTONS AND THEIR FUNCTIONS

The Sportline 345 Pedometer has 3 buttons for operating and programming: MODE/
RESET (located on the front of the unit below the display) and on the back panel of 
the unit, the SET and the + (Adjust/increase) buttons. 

•  Operating Mode: Scrolls through display modes.

•  Press & Hold: Resets pedometer data 

•  Programming Mode: Adjusts (decreases) information being adjusted.

•  Operating Mode: Press & Hold to enter the Programming Sequence. 

•  Programming Mode: Accepts the information being adjusted and advances to the 

next setting.

•  Programming Mode: Adjusts (increases) information being adjusted.

2- REMOVING BATTERY INSULATOR TAB

3- BUTTONS AND THEIR FUNCTIONS

1- INTRODUCTION

Back cover

345 PEDOMETER

USER GUIDE

/INSTRUCTION MANUAL

Congratulations on your purchase of a Sportline 345 Pedometer. The 345 Pedometer 
features a highly advanced pedometer technology that accurately measures your 
body movements when worn from multiple locations on the body and in multiple 
orientations.

Please keep in mind your pedometer is a sensitive technical instrument. With 
proper care and maintenance, it will last for many years. However, improper 
care and handling can cause the various sensors to be damaged and to stop 
functioning.

Please read all sections of this manual carefully and become fully familiar with 
the operation of the pedometer before using it in the fi eld. Proper setup and 
operation will greatly enhance the pedometer’s usefulness and your enjoyment. 
The steps for the programming or operation are adjacent to the screen illustration. 
Key points and important information are shown in highlighted blocks.

If you have questions, comments or need assistance with your Sportline 
Pedometer, you may contact Customer Support by calling 1-866-694-4575.

NOTE: In order to activate your pedometer after purchase, you must remove the 
battery insulator tab inside the battery compartment.  

1.  Locate the tab on the back of the pedometer.  

2.  Firmly grasp the tab and pull away from the pedometer until completely 

removed from the unit.

3.  Remove the label that appears on the pedometer display.

345 PEDOMETER

www.sportline.com

Walking Advantage by Sportline

TM

 is distributed for EB Sport Group, 

Yonkers, NY. in Canada by / Walking Advantage par Sportline

TM

est distribué pour EB Sport Group, au Canada par ACI Brands Inc, 
2616 Sheridan Drive, Oakville, Ontario L6J-7Z2.  

All Rights Reserved/Touts droits reservé ©2012

WV1056IS02SCC

Fold 1

Fold 2

Fold 3

Fold 3

5- PROGRAMMING THE PEDOMETER

4.  Adjust Height by PRESSING the + or - buttons. PRESS the SET button to accept 

value.   

5.  This pedometer has an automatic stride length calculator that sets your length 

based on your height. PRESS the SET button to accept this value or you can 
adjust your Stride Length (see “Determining Stride Length” on the opposite 
page) by PRESSING the + or MODE buttons. 

6.  PRESS the SET button. The unit is now programmed and ready for use!

4- PROGRAMMING THE PEDOMETER

In order to ensure exercise data is as accurate as possible, you must complete the 
following steps to enter your personal profi le. The display will prompt you what 
information is being programmed. Adjust information by PRESSING + (to increase) 
OR MODE/RESET (MODE) (to decrease). Accept value and advance to the next setting 
by PRESSING SET.

1.  Enter the Programming Sequence by PRESSING & HOLDING the SET button on 

the back of the unit for approximately 3 seconds. 

2.  Select unit of measure (metric or imperial) by PRESSING the + or MODE buttons 

on the back of the unit. PRESS the SET button again. 

3.  Adjust Weight (in pounds or kilograms) by PRESSING the + (to increase) or MODE 

(to decrease) buttons.  PRESS the SET button to accept value and advance to set 
Height.

To adjust value:

To accept and advance:

To adjust value:

To accept and advance:

Scroll through display 

modes:

6- OPERATING THE PEDOMETER

7- RESETTING PEDOMETER DATA

The 345 Pedometer automatically begins capturing data once movement 
occurs.  There are no Start or Stop buttons to push. 

Scroll through display modes: STEPS, DISTANCE, CALORIES AND EXERCISE TIME 
by PRESSING THE MODE/RESET BUTTON.

1.  PRESS & HOLD the MODE/RESET button on the front of the unit.  

2.  Continue holding as the display reads “RESET”. 

3.  When pedometer data reads zeros (O), RELEASE THE MODE/RESET button. 

The unit is now ready for a new workout.

 

NOTE: Your personal profi le settings will be saved. 

WV1056IS02SCC

9/11/12

Ron