Casablanca Fan Company W-85 User Manual

W-85 WALL CONTROL PREPARATION

WALL CONTROL AND HARDWARE (not to scale)

Before installing the W-85 wall control you will need to  

check and see if you will need to change the bezel on 

the front of the wall control from WHITE to ALMOND. 

If you are going to use white, skip these steps and go 

to wall control installation starting on page 3. If you are 

going to use the ALMOND bezel and wall plate you 

will first need to change the bezel on the front of the 

switch before installing the switch in to the wall.

Step 16a. Locate  the four (4) tabs holding the bezel to 

the front of the switch, then press in on each tab one at 

a time, removing the bezel as shown in Figure #1. 
Step 16b. Locate the rubber key pad attached to 

the four (4) locating pins as shown in Figure #2 and 

remove rubber key pad from the WHITE bezel, also 

as shown in Figure #2. 
Step 16c. Reinstall the rubber key pad on to the 

four (4) locating pins located on the almond bezel as 

shown in Figure #3.