Datalogic Scanning M8300 User Manual

POWERSCAN

®

 D8330/M8300 

®

 

  Read the restore default parameters code below. 

Restore PowerScan

®

 D8330 Default 

Ì$+$*oΠ

After reading the above code, go to par. 4.8 Interface Selection. 

 
 

 

A rapid configuration procedure has been devised for point-to-point applications 
where a single reader is associated exclusively with its own BC-80x0 base station 
and where it is not necessary to set the Date and Time parameters. 

A special pre-printed bind-address label provided in the BC-80x0 base station 
package can be used to bind the PowerScan

 M8300 reader to the base station with 

the address coded on the label. The address is also written numerically on the label 
to be easily recognized. Valid addresses are in the range from 0000 to 1999. Make 
sure that all cradles used in the same area have different addresses. 

To rapidly configure your point-to-point application: 
 

Apply the bind-address label onto the BC-80x0 base station as indicated in 
the BC-80x0 Quick Reference Guide. 

 

 

When the BC-80X0 cradle is connected and powered, read the 
Bind-Address label to pair the PowerScan

®

 M8300 to the BC-80X0 cradle. 

The green LED on the PowerScan

®

 M8300 will blink: the reader is ready to 

be positioned onto the cradle. 

 

 

Firmly position the reader onto the cradle within 10 seconds, a beep will be 
emitted, signaling that the BC-80X0 cradle has been paired to the 
PowerScan

®

 M8300, and the green LED on the reader will go off. 

 
If it ever becomes necessary to change the reader, 
just read the bind-address label applied to the cradle 
and position the new reader onto the cradle. 
 
Do not use multiple readers with this configuration 
method. 

Configure the BC-80X0 cradle, refer to the “BC-80X0 Quick Reference 
Guide”. 

Green LED