Firstech, LLC. CM1000A User Manual

 

 

- 20 - 

 

CONNECTOR 1 

 
Pin 1 Red- Constant 12-volt (+) positive power input for the control module. This wire 

must be connected to a constant 12-volt (+) positive source. The proper wire will 
test 12-volt (+) positive with the key in the off position, while key is in the on 
position and during crank. 

 
Pin 2 Green/White- Parking light (+) positive output. Connect this wire to the (+) 

positive parking light wire generally at the parking light switch or behind the fuse 
box. The proper wire will test 12-volts (+) positive when the parking light switch is 
in the on position. 

 
Pin 3 Red/White- Constant 12-volt (+) positive power input for the starter and accessory 

on-board relays. This wire must be connected to a constant 12-volt (+) positive 
source. The proper wire will test 12-volts (+) positive with the key in the off 
position, while the key is in the on position and during crank 

 
Pin 4 White- Accessory 12-volts (+) positive output. This wire must be connected to the 

heater and A/C blower motor wire. The proper wire will test 0-volts with the key in 
the off position, 12-volts (+) positive while key is in the on position, 0-volts while 
cranking and back to 12-volts (+) positive with the key in the on position 

. 
Pin 5 Violet- 250mA (-) negative output when armed and remote started. This wire will 

provide a (-) negative output when system is locked and armed and during remote 
start for anti-grind. (Note: This wire can also be used to trigger after-market L.E.D. 
kits and other after-market accessories. Output must be diode isolated when used to 
trigger after-market accessories.) 

 
Pin 6 Yellow- Starter 12-volt (+) positive output. This is pre-wired to pin 87a of the 

starter interrupt relay. This wire will provide12-volts (+) positive to the vehicles 
starter. The proper wire will test 0-volts with the key in the off position, 0-volts 
while the key is in the on position and 12-volts (+) positive during crank. (Note: 
The vehicle starter wire will need to be cut. The yellow wire from pin 87a on the 
starter interrupt relay will go to the starter side of the vehicles starter wire. The 
yellow/black wire from pin 30 of the starter interrupt relay will go to the key side of 
the vehicles starter wire.) 

Pin 7 Green and Red –Ignition output and input. This wire must be connected to the 

vehicles ignition to power up all accessories and to trigger remote programming. 
The proper wire will test 0-volts with the key in the off position, 12-volts (+) 
positive while the key is in the on position and 12-volts (+) positive during crank. 
(Note: Red wire is the ignition input for the pre-wired starter kill relay.)