Firstech, LLC. CM4200 User Manual

 

 

- 29 - 

Pin 6 Green –Ignition input. This wire must be connected to the vehicles ignition to 

trigger remote programming. The proper wire will test 0-volts with the key in the 
off position, 12-volts (+) positive while the key is in the on position and 12-volts 
(+) positive during crank.  

Pin 7 Violet- Dome light 250mA (-) negative output. This is an optional output that will 

provide a 30 second (-) negative output after system is unlocked for dome-light 
supervision. 

 
Pin 8 Orange- Factory alarm re-arm 250mA (-) negative output. This is an optional 

output that will provide a (-) negative pulse output during lock, after crank and after 
ignition shut down.  

 
Pin 9 Orange/White- Factory alarm disarm 250mA (-) negative output. This is an 

optional output that will provide a (-) negative pulse output during unlock and 
before ignition is turned on. 

 
 

CONNECTOR 3 

 
Pin 1 Gray/Black- Hood-pin (-) negative input. This is an optional input that will 

monitor when the vehicles hood is opened.. (Note: This wire will also trigger alarm 
when system is armed.) 

. 
Pin 2 Violet/Black- Trunk-pin (-) negative input. This is an optional input that will 

monitor when the vehicles trunk is opened. (Note: This wire will also trigger alarm 
when system is armed.) 

 
Pin 3 Red/White- Door trigger (-) negative input. This wire monitors (-) negative trigger 

door-pins. The proper wire will provide a (-) negative trigger only when the doors 
are opened.  

 
Pin 4 Red- Door trigger (+) positive input. This wire monitors (+) positive trigger door-

pins. The proper wire will provide a (+) positive trigger only when the doors are 
opened.  

 
Pin 5 Black /White- Optional sensor 2

nd 

stage (-) negative input. (Instant trigger) 

 
Pin 6 Gray/White- Optional sensor 1

st

 stage  (-) negative input. (Warn away)