Magnavox 50ML8205D/17 User Manual

19

After switching on the TV, select the appropriate input source using the front panel buttons 

or the remote control as follows:

• Press ATV, DVI/HDMI, YPbPr, DTV, AV, SV, or VGA on the remote control to switch to 

the respective input.

• Press  the  ENTER/SOURCE button on the front panel of the TV repeatedly to switch 

through all the input sources.

• Press SOURCE on the remote control to select the source 

from the on-screen menu. A list of input sources is displayed 

on the screen. Select the appropriate input using the cursor 

keys and press OK on the remote control to display the input 

signal.

Use one of the following methods to change channels:

• Press the channel up or down buttons on the front panel or the remote control to switch 

to the previous or next channel.

• Press the number keys on the remote control to directly key in a channel number.

To adjust volume, do the following:

• Press the volume up or down buttons on the front panel or the remote control to 

increase or decrease the volume.

• Press the mute button (see page 4) to disable the volume. Press the button again to 

restore sound.

• Unless the TV is not going to be used for an extended period of time, the main power 

switch can be left in the ON position without consuming a lot of power.

• After you switch off the TV, the power LED flashes red/green for 10 seconds, flashes red 

for approximately 40 seconds and then turns red when the system is powered off. When 

the LED is flashing red, the TV is in its final cooling phase and the system will not respond 

to any commands from the remote control or front panel buttons. Wait until the power 

LED stops flashing for about 1 minute before switching on the TV again.