GE 0150-0193G User Manual
0150-0193G
16
DVMRe Triplex
Power-up procedure
Power Supply Input
Once the system installation is complete, apply
power in the following order:
power in the following order:
1. Energize the monitors and all of the cameras.
2. Energize the DVMRe
Triplex.
Voltage: 12 Volt DC
Power: 60 Watt (5 Amp)
Connector: 2.1mm barrel, center positive
Once power is applied to the unit, it will begin its power-up procedure. The unit will begin by displaying
the software version on Monitor-A, then the unit will begin recording automatically.
the software version on Monitor-A, then the unit will begin recording automatically.
Check Video Input Quality
Check the picture quality by selecting each camera for full screen display. If the picture quality is poor,
check the following items:
check the following items:
•
The BNC connections.
•
The loop-through terminations.
•
The video levels of incoming signals.
•
The possibility of ground loops.
•
Consult the camera’s installation instructions for additional information about proper camera setup.
Check Record And Playback Quality
Record for at least three minutes at the default record rate
.
Then play back the recording, selecting
each camera for full screen display. Check the playback picture quality.
1.9 Minimum Recommended Menu Setup
After installation is complete, it is strongly recommended that, as a minimum, the items in the
QuickInstall menu be configured before the unit is used. All the features located in the QuickInstall
menu are also found in the Main menu. These items are provided in the separate QuickInstall menu
as a convenience for the installer.
QuickInstall menu be configured before the unit is used. All the features located in the QuickInstall
menu are also found in the Main menu. These items are provided in the separate QuickInstall menu
as a convenience for the installer.
For information about accessing and configuring the menu system, see Section 3.
To find detailed information in this manual about configuring each item in the QuickInstall menu, use
the following table to locate the main menu location of each item in the QuickInstall menu.
the following table to locate the main menu location of each item in the QuickInstall menu.
QuickInstall
Menu Item
Main Menu Location
Section in
Manual
Change the time Main Menu
→
Time/Date
→
Set Time
3.8
Change the date Main Menu
→
Time/Date
→
Set Date
3.8
Edit Camera
Titles
Titles
Main Menu
→
Camera Setup
→
Camera Titles
→
Edit Titles
3.14
Camera Disable Main Menu
→
Camera Setup
→
Camera Disable
3.14
Record Quality
Main Menu
→
Record
→
Record Quality
3.10
Installer
Password
Password
Main Menu
→
Passwords
→
Installer Password
3.20
Auto Disable
Now
Now
Main Menu
→
Camera Setup
→
Camera Disable
→
Auto
Disable Now
3.14