GE BusSecure User Manual

BusSecure User Manual 

Troubleshooting 

 

 

0150-0263A / May 2003 

29 

 

To reset the factory settings, remove the cover panel 
and hold down the indicated button (

) for 5 seconds. 

This action will restore the default IP address to 
3.18.173.0. 

 

The status lights will alert you to the status of the DVR. DVR status lights should not be confused with 
DVR LEDs. The LEDs are located on the front of the removable DVR unit. The term status lights is used 
to refer to any lights or LEDs connected to the two outputs from the DVR, such as the BusSecure Panic 
Button. Status lights can be mounted anywhere depending upon the installation and are optional devices. 

Note: Some properties customize the DVR status outputs and use another device (such as an IO or PLC) to control the lights. 

 

Output 1 corresponds to Check System and Output 2 corresponds to Normal. 

Output 2: the DVR is running and capturing images. 

Output 1 and 2: the DVR is running and capturing images with an exception (e.g., loss of signal 
from a camera). Check the Recorder Log of the DVR to investigate further. 

Output 1: the DVR has encountered an error and is not capturing images. 

No lights: the DVR is not running. 

 

 

 

 (in conjunction with a normal status light if 

installed): 

• 

Camera failure 

• 

Camera enabled but not installed 

• 

Event data deleted before the configured minimum time has passed 

• 

Surveillance data deleted before the configured minimum time has passed