888 Digital HD4000 User Manual

Page of 27
 
 
Installing the batteries 
Remove the battery cover from the remote control and put two AAA size batteries 
inside the compartment. 
The diagram inside the battery compartment shows the correct way to install the 
batteries. 
 
 
Caution: 
 
1. Keep batteries out of children’s reach. 
2. Don’t attempt to recharge, short-circuit, disassemble, heat or throw the batteries 
into the fire. 
3. Always replace both batteries at the same time. Never mix new and old batteries 
or batteries of a different type. 
4. If you don’t intend to use the remote controller for an extended period, remove 
the batteries to prevent possible leakage and corrosion. 
5. Do not drop, apply shock or step on the remote control. 
6. Do not spill water on the remote control. 
 
Notes: 
If the receiver does not operate when operating the remote control from a close 
range, you need to replace the batteries. 
 
Using the Remote Control 
 
1. To use the remote control, point it towards the front of the digital set top box. 
2. The remote control has a range of up to 7 metres from the set top box at an 
angle of up to 60 degrees. 
3. The remote control will not operate if its path is blocked. 
 
Note:
 
Sunlight or very bright light will decrease the sensitivity of the remote control.