Clover Electronics CDR 0440 User Manual

25

for all channels.

(FRAME RATE, QUALITY, RECORDING, PRE REC, POST EVT REC)

Set the frame rate for the specified channel. The sum of the frame rate 

values from each channel cannot exceed the maximum frame rates for a 

specific recording resolution. 

120/100fps: 352*240(NTSC)/352*288(PAL)

60/50fps: 704*240(NTSC)/704*288(PAL)

30/25 fps: 704*480(NTSC)/704*576(PAL)

Select the recording quality for the specified channel. Options are: 

Network, Standard, High, Superior and Ultra.

Assign the recording mode for each channel. Options are: Continuous, By 

Motion, By Sensor, By Schedule or Disable.

Enable/Disable electric light control. When alarm output is connected to an 

electric light for the motion detection signal, user needs to set ELECTRIC 

LIGHT CONTROL to ON. Then the motion detection signal will not be 

activated for 2-3seconds after alarm output is turned off. 

Enable setting up to 4 sensors of 9 sensors for the specified channel using 

the control button (

ൖ Ÿ൘ ź

).

Enable/disable pre-event recording. Pre-event recording time is 3 seconds 

and only intra-frames are recorded for pre-event recording.

Set the post event recording time duration for the specified channel. (10-

30 seconds)

Enable/disable audio recording for the specified channel.

z Fixed-available on only from channel 1 to channel 4.

Set the recording schedule. Press SEL to go to schedule setup screen.