Precor EFX 5.25 User Manual

Certain features remain hidden and can only be accessed 
using special key presses. Read this section if you want to:

•

Select the units of measure

•

View the odometer

•

Display the number of hours you have used your EFX

•

View the software versions and part numbers

•

Check the error log

In general, you would only access this information if 
directed to do so by Precor Customer Support.

•

Always start at the Precor banner.

•

The advanced programming and troubleshooting mode 
is accessed by pressing and holding the ENTER key at 
the Precor banner, then entering the appropriate key 
combination. Any remaining key presses must occur 
quickly and without pause.

•

The QUICKSTART key is disabled while in advanced 
programming mode.

•

Use the arrow keys to change blinking prompts.

•

Press ENTER to make selections and RESET to return 
to the Precor banner.

The EFX can display measurements in either metric or U.S. 
standard. The default factory setting is set to display U.S. 
standard. To change this setting, perform the following 
steps:

1. At the Precor banner, press and hold ENTER while 

pressing the following keys in sequence without pause:

RESET, CROSSRAMP 

▼, RESISTANCE ▲

Use the arrow keys to select a unit of measure (either 
METRIC or U.S.).

2. When you are ready, press ENTER to accept the 

displayed setting. The display indicates the setting is 
saved. Press RESET to return to the Precor banner.

Note: Changing the display to metric measurements 
affects the default settings. Distances and the odometer 
values are converted to and appear in kilometers (KM). 
Speed appears in kilometers per hour.