Horizon Fitness LS 635E User Manual

A) Open 

B) Carefully pull the 

CONSOLE CABLES through the CONSOLE MAST using the twist tie located inside the 

CONSOLE MAST. 

C) Attach the 

CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT 

D) Insert the 

TOP FRONT COVER, followed by the TOP BACK COVER and snap them together.

E) Slide 

CONSOLE MAST BOOT down to seal the console mast hole.

NOTE: There is NO hardware bag for this step. All hardware is pre-installed. 

A) Remove 

PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.

B) Slide 

LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.

C) Slide 

UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are 

joined together completely. Secure 

UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET 

SCREWS.

D) Snap the front and back 

HANDLEBAR COVERS together onto the UPPER HANDLE BARS. 

Note the position of the snap tabs on the covers before snapping into position.

E) Repeat on other side.

After handlebars are assembled they will rotate freely – be cautious. Until the 
machine is fully assembled, do not grab the handlebars for support.

LS_635E_User_Guide_Rev.1.2.indd   8-9

3/29/07   1:07:29 PM