Intel D850GB User Manual
21
2 Installing and Replacing Desktop Board
Components
This chapter tells you how to:
• Install and remove an AGP retention mechanism and card
• Install the I/O shield
• Install and remove the board
• Install the processor retention mechanism and board in the chassis
• Install a processor
• Install and remove memory
• Replace the battery
• Connect the IDE cable
• Set the jumpers
• Clear passwords
• Install and remove an AGP retention mechanism and card
• Install the I/O shield
• Install and remove the board
• Install the processor retention mechanism and board in the chassis
• Install a processor
• Install and remove memory
• Replace the battery
• Connect the IDE cable
• Set the jumpers
• Clear passwords
Before You Begin
CAUTION
Before you install this board in a chassis, see Appendix B for regulatory requirements and
precautions.
precautions.
• Always follow the steps in each procedure in the correct order.
• Set up a log to record information about your computer, such as model, serial numbers,
• Set up a log to record information about your computer, such as model, serial numbers,
installed options, and configuration information.
• Electrostatic discharge (ESD) can damage components. Perform the procedures described in
this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam
pad. If such a station is not available, you can provide some ESD protection by wearing an
antistatic wrist strap and attaching it to a metal part of the computer chassis.
pad. If such a station is not available, you can provide some ESD protection by wearing an
antistatic wrist strap and attaching it to a metal part of the computer chassis.
WARNINGS
The procedures in this chapter assume familiarity with the general terminology associated with
personal computers and with the safety practices and regulatory compliance required for using
and modifying electronic equipment.
personal computers and with the safety practices and regulatory compliance required for using
and modifying electronic equipment.
Disconnect the computer from its power source and from any telecommunications links,
networks, or modems before performing any of the procedures described in this chapter.
Failure to disconnect power, telecommunications links, networks, or modems before you open
the computer or perform any procedures can result in personal injury or equipment damage.
Some circuitry on the board can continue to operate even though the front panel power button is
off.
networks, or modems before performing any of the procedures described in this chapter.
Failure to disconnect power, telecommunications links, networks, or modems before you open
the computer or perform any procedures can result in personal injury or equipment damage.
Some circuitry on the board can continue to operate even though the front panel power button is
off.