Fujitsu F9600 User Manual
PN: 1725-36134-001_E.doc
13
Interface Implementation
This section describes the recommended programming to use the
SpectraLink 6000 System (MCU) or SpectraLink 8000 Wireless
Telephone system (Gateway) with a Fujitsu F9600 telephone system.
The procedures assume:
SpectraLink 6000 System (MCU) or SpectraLink 8000 Wireless
Telephone system (Gateway) with a Fujitsu F9600 telephone system.
The procedures assume:
•
The F9600 is installed and operational in an approved
configuration. See the Telephone Switch Interface Matrix
document for tested configurations.
configuration. See the Telephone Switch Interface Matrix
document for tested configurations.
•
A trained Fujitsu technician or system administrator will be on
site with the SpectraLink installer to program the system.
site with the SpectraLink installer to program the system.
•
The SpectraLink 6000 System or SpectraLink 8000 Telephony
Gateway is installed and the handsets are available for
programming.
Gateway is installed and the handsets are available for
programming.
Set the Switch Interface Type
SpectraLink 6100 MCU
The SpectraLink 6100 Master Control Unit requires the switch
interface type to be configured using the front panel buttons. The
configuration procedures are detailed in SpectraLink 6100 MCU:
Installation and Operation.
interface type to be configured using the front panel buttons. The
configuration procedures are detailed in SpectraLink 6100 MCU:
Installation and Operation.
SpectraLink 6300 MCU
When configuring the SpectraLink 6300 MCU, the PBX interfaces are
available as sub-menu selections when defining the Interface Module
type using the SpectraLink 6300 MCU Operator’s Console. Refer to
SpectraLink 6300 MCU: Operator’s Console for details on configuring
the Interface Modules.
available as sub-menu selections when defining the Interface Module
type using the SpectraLink 6300 MCU Operator’s Console. Refer to
SpectraLink 6300 MCU: Operator’s Console for details on configuring
the Interface Modules.
2