Sony KP 53HS10 Manual

Page of 66
4
D:\JN\KP-53HS10\KP53HS10GB\407416311KP53HS10USA\02US-
KP53HS10USA\04TOCSAF.fm
masterpage:Left
Model name1[KP-53HS10] Model name2[KP-61HS10]
[4-074-163-11 (1)]
If a snapping or popping 
sound from a projection TV 
set is continuous or frequent 
while the projection TV is 
operating, unplug the 
projection TV and consult 
your dealer or service 
technician. It is normal for 
some projection TV sets to 
make occasional snapping or popping sounds, 
particularly when being turned on or off.
IIIIn
n
n
ns
s
s
st
tt
ta
a
a
all
ll
ll
lla
a
a
at
tt
tiiiion
on
on
on
Water and Moisture
Do not use power-line 
operated sets near water—
for example, near a bathtub, 
washbowl, kitchen sink, or 
laundry tub, in a wet 
basement or near a 
swimming pool, etc.
Accessories
Do not place the set on an 
unstable cart, stand, table or 
shelf. The set may fall, 
causing serious injury to a 
child or an adult, and serious 
damage to the set. Use only a 
cart or stand recommended 
by the manufacturer for the 
specific model of projection 
TV.
An appliance and cart 
combination should be 
moved with care. Quick 
stops, excessive force, and 
uneven surfaces may cause 
the appliance and cart 
combination to overturn.
Ventilation
The slots and openings in the cabinet and in the 
back or bottom are provided for necessary 
ventilation. To ensure reliable operation of the set, 
and to protect it from overheating, these slots and 
openings must never be blocked or covered.
- Never cover the slots and 
openings with a cloth or 
other materials.
- Never block the slots and 
openings by placing the set 
on a bed, sofa, rug or other 
similar surface.
- Never place the set in a 
confined space, such as a 
bookcase, or built-in cabinet 
unless proper ventilation is 
provided.
- Do not place the set near or 
over a radiator or heat 
register, or where it is 
exposed to direct sunlight.
Power-Cord Protection 
Do not allow anything to rest 
on or roll over the power 
cord, and do not place the set 
where the power cord is 
subject to wear or abuse.
Antennas
Outdoor Antenna Grounding 
— If an 
outdoor antenna is installed, follow the precautions 
below.
An outdoor antenna system should not be located 
in the vicinity of overhead power lines or other 
electric light or power circuits, or where it can 
come in contact with such power lines or circuits.
WHEN INSTALLING AN OUTDOOR 
ANTENNA SYSTEM, EXTREME CARE 
SHOULD BE TAKEN TO KEEP FROM 
CONTACTING SUCH POWER LINES OR 
CIRCUITS AS CONTACT WITH THEM IS 
ALMOST INVARIABLY FATAL.
Be sure the antenna system is grounded so as to 
provide some protection against voltage surges and 
built-up static charges. 
Section 810 of the National Electrical Code (NEC) 
in USA and Section 54 of the Canadian Electrical 
Code in Canada provides information with respect 
to proper grounding of the mast and supporting 
structure, grounding of the lead-in wire to an 
antenna discharge unit, size of grounding 
conductors, location of antenna discharge unit, 
connection to grounding electrodes, and 
requirements for the grounding electrode.