Pentair and P8 User Manual

Page 26

One button on the Four 
Function Remote does not 
operate.

Check programming first. If 
the Four Function Remote 
is programmed correctly, the 
button may be shorted.

NOTE   If dip switch 1 
(CLEANER) is on, button # 3 
on the Four Function Remote 
will not operate when in spa 
mode unless this button is 
programmed to a circuit other 
than Aux 1.

Replace the Four Function Re mote. Use MENU, 
REVIEW, SPA SWITCH to check pro gram ming.

Pool cleaner booster pump 
turns on without the filter pump 
being on, and can run with the 
spa on.

System is not recognizing DIP 
switch #1 is on. 

NOTE  Before turning on any 
DIP switches, first turn off all 
equipment. Do not program 
any auxiliaries until all DIP 
switches are set.

Turn off all equipment buttons, then turn off 
power to the system, finally turn off, then on, DIP 
switch #1. Turn on power and test system.

System comes on at times that 
are not programmed.

Phantom programs.

At the PDA press MENU, then select 
PROGRAM. Make note of all programs (the 
Four Function Remote setting, labels, and 
temperature settings) then turn off all DIP 
switches and go to the PDA. CLEAR MEM O RY, 
reprogram and try system again.

Heater will not fire. Heater LED 
will not light in "Service Mode".

Water temperature sensor not 
installed or defective.

Check water temperature sensor.

LCD screen display stays on 
startup screen.

No communication between 
PDA Handheld Remote and 
Power Center J-box.

Change the Frequency Channel. See Section 
3.7.3.