Sterling 882.00249.00 User Manual
2–Pump 12-Station Controllers
Chapter 8: Service Only Information
59
SET PUMP STAGE TIME?
NO/YES
STAGE DELAY: 3.000s
PRESS ENTER TO SAVE
Setting the Pump Stage Time
Pump stage time is a delay that prevents both pumps from engaging at the same time.
Although rare in a two-pump system, both pumps can sometimes start at the same time. This
condition causes an excess of current on the electrical system from such a surge.
Pump stage time is a delay that prevents both pumps from engaging at the same time.
Although rare in a two-pump system, both pumps can sometimes start at the same time. This
condition causes an excess of current on the electrical system from such a surge.
The pump stage time delay defaults to 3.0 seconds and should not be altered unless you are
instructed to do so by the Service Dept.
instructed to do so by the Service Dept.
At the above message prompt:
1. Press the YES key to enter the Pump Stage Time menu.
Using the keypad:
2. Enter the new time and press the ENTER key to save the new setting.