Sterling XXX10-80 User Manual

10-Pump, 80-Station Controller 

Chapter 3:  Installation 

21 

 

 

2.  Making sure that the cable is completely straight, carefully close the hinged 

assembly, and apply firm, even pressure until the first latch locks into place. 

 

The latch has two catches; the first loosely holds the connector on the cable, the 
second requires more pressure to close the connector tightly. The cable must be in the 
correct position for the connector to close properly. 

3.  Drive the two screws at the center points about halfway down; first on the latch side, 

then the hinge side. 

4.  Continue to tighten the screws a little at a time until fully tightened; no more than 15 

inch-pounds (5.6 N

•

m) of torque. 

Connecting the Controller to the Network 
To connect the controller to the network, make sure that the KwikLink connector is properly 
installed on the flat grey data cable. To connect: 

1.  Attach the keyed round connector to the terminal of the controller marked DeviceNet. 

Tighten the cord grip ring until snug. 

2.  Align the square connector of the grey drop cable so the cable leads down from the 

connector. Evenly press the square connector onto the top of the KwikLink 
connector. It should make two audible snaps when properly seated. 

3.  Dress the excess cable with cable ties so it does not interfere with operation and gives 

a pleasing appearance. 

After selecting a location and installing the remote interface, connect it to the main controller: 

1.  Install the Ethernet switch in a location safe from electrical interference and physical 

damage. 

2.  Install the remote interface(s) in their desired locations.