Sterling XXX10-80 User Manual
10-Pump, 80-Station Controller Chapter 3: Installation
40
Setting Up Stations
Before starting the system, you must define several settings for each station, such as which
pump conveys material to it and whether the station has a slide gate. This section first
discusses how to use the controller’s menu system to configure stations. The table on pp. 63–
67 discusses the individual choices.
Before starting the system, you must define several settings for each station, such as which
pump conveys material to it and whether the station has a slide gate. This section first
discusses how to use the controller’s menu system to configure stations. The table on pp. 63–
67 discusses the individual choices.
Setting Up a Single Station
1. Go to the Station Status screen if needed.
To reach this screen from any other screen, touch Stations on the right-hand side
of the screen. The Station Status screen appears. Depending on which model you
have, your screen will appear as one of the following:
of the screen. The Station Status screen appears. Depending on which model you
have, your screen will appear as one of the following:
2. Touch the icon for the station you want to set up, and hold it for several seconds.
The Station n Operator Settings screen for the selected station appears:
Touch Station Setup at the Station n Operator Settings screen.
The Station n Setup screen appears: