Sterling XXX10-80 User Manual
10-Pump, 80-Station Controller Chapter 8: Appendix
86
CompactLogix L35E Upgrade
Use this procedure to upgrade the software on a CompactLogix PLC for use on a 10 Pump – 80 Station
Convey Control.
1. If the control is off, turn it on and wait for the control to power up.
2. Verify that the key switch on the front of the PLC CPU is in the RUN position.
3. Remove existing compact flash card from the PLC CPU by pressing the retaining clip to the right
2. Verify that the key switch on the front of the PLC CPU is in the RUN position.
3. Remove existing compact flash card from the PLC CPU by pressing the retaining clip to the right
and pulling the compact flash card straight out (Fig 5).
Fig 5
4. Insert the configuration compact flash card containing the new version of the software labeled
PLC Configure 744.00130.00 into the PLC CPU.