Sterling XXX10-80 User Manual

10-Pump, 80-Station Controller 

Chapter 8:  Appendix 

89 

Use this procedure to setup a new VersaView display or to upgrade a VersaView display for use on a 
Sterling 10 Pump – 80 Station Convey Control.   
 

1.  Remove the compact flash card from the VersaView if one is installed by pressing the Eject 

Button (Fig 9). 

 

 

Fig 9 

2.  If you are setting up a Remote Display, disconnect the Ethernet cable connecting the VersaView 

to the network.  If you are setting up the Primary Display, leave the Ethernet cable connected. 

3.  Cycle power on the VersaView.