2WIRE F110 User Manual

Before your machine will be ready to make 
copies or receive faxes, you must load paper 
into the machine. Use paper letter, 8.5 x 11 
Inch (216 × 279 millimetres). Your machine 
works with normal copier paper and with 
typewriter paper (0.13 – 0,2 lb/m

2

) (see 

user manual chapter Installation / Paper).

1  Separate the paper sheets by fanning 

them out, then align them by tap-
ping edge of the stack lightly against 
a fl at surface. Th

  is will prevent several 

sheets of paper from being drawn in 
all at once.

2  Remove the cover from the paper tray. 

Put in only as much paper as will fi t 
under the raised limit markers on the 
upper edge of the paper input tray 
(see also the drawings on the cover 
of the paper input tray). You can load 
up to 250 sheets into the paper input 
tray.

Insert the document output tray into the 
two openings under the operation panel.

Insert the document input tray into the 
two openings in the cover. Th

 e document 

support should snap securely into place.

Pull the paper output tray out of the paper 
tray cover.

3  Press the paper down until the lever 

(A) snaps into place at the rear of the 
paper input tray.

4  Place the cover back on the paper input 

tray. Push the paper input tray into the 
machine all the way to the stopping point.