Panasonic KX-FG6550 User Manual
10. Help
95
For assistance, please visit http://www.panasonic.com/consumersupport
10.2 Error messages – Display
If the unit detects a problem, one or more of the following messages will appear on the display.
10.2.1 Base unit
Display
Cause and Solution
“
BUSY”
L
The called handset is in use.
L
Other users are using the line(s). Wait until {LINE1} or {LINE2}
turns OFF.
turns OFF.
L
The handset you tried to copy phone book items to is in use.
L
The handset you are calling is too far from the base unit.
L
Privacy mode is turned ON for the call you tried to join (page 52).
“
CALL SERVICE”
L
There is something wrong with the unit. Contact our service
personnel.
personnel.
“
CHECK DOCUMENT”
L
The document was not fed into the unit properly. Re-insert the
document. If misfeeding occurs frequently, clean the document
feeder rollers (page 110) and try again.
document. If misfeeding occurs frequently, clean the document
feeder rollers (page 110) and try again.
L
Attempted to send a document longer than 600 mm (23
5
/
8
"). Press
{
STOP} to remove the document. Divide the document into two or
more sheets, and try again.
“
CHECK MEMORY”
L
The base unit memory (telephone numbers, parameters, etc.) has
been erased. Re-program.
been erased. Re-program.
“
CHECK PAPER”
L
The recording paper is not installed or the unit has run out of paper.
Install paper and press {START} to clear the message.
Install paper and press {START} to clear the message.
L
The recording paper was not fed into the unit properly (page 109).
Reinstall paper (page 17) and press {START} to clear the
message.
Reinstall paper (page 17) and press {START} to clear the
message.
L
The recording paper has jammed near the recording paper
entrance. Clear the jammed paper (page 107) and press {START}
to clear the message.
entrance. Clear the jammed paper (page 107) and press {START}
to clear the message.
“
COVER OPEN”
“
CHECK FILM”
L
The covers are open. Close them.
L
The ink film is empty. Replace the ink film with a new one (page
16).
16).
L
The ink film is not installed. Install it (page 14).
L
The ink film is slack or creased. Tighten it (see step 5 on page 15).
“
DENIED”
L
When you tried to monitor an extension, the room monitor feature
of the destination extension was set to OFF (page 53).
of the destination extension was set to OFF (page 53).
“
FAX IN MEMORY”
L
The unit has a document in memory. See the other displayed
message instructions to print out the document.
message instructions to print out the document.
“
FAX MEMORY FULL”
L
The memory is full of received documents due to a lack of
recording paper, a lack of ink film or a recording paper jam. Install
paper (page 17), install ink film (page 14) or clear the jammed
paper (page 107).
recording paper, a lack of ink film or a recording paper jam. Install
paper (page 17), install ink film (page 14) or clear the jammed
paper (page 107).
L
When performing memory transmission, the document being
stored exceeded the memory capacity of the unit. Send the entire
document manually.
stored exceeded the memory capacity of the unit. Send the entire
document manually.
FG6550-PFQX2225ZA-en.book Page 95 Monday, August 8, 2005 8:16 PM