Agilent Technologies E7405A User Manual
12
Chapter 1
Making Basic Measurements
Comparing Signals
Figure 1-2
Using the Marker Delta Function
Signal Comparison Example 2:
Measure the frequency and amplitude difference between two signals
that do not appear on the screen at one time. (This technique is useful
for harmonic distortion tests when narrow span and narrow bandwidth
are necessary to measure the low level harmonics.)
that do not appear on the screen at one time. (This technique is useful
for harmonic distortion tests when narrow span and narrow bandwidth
are necessary to measure the low level harmonics.)
1.
Perform a factory preset by pressing
Preset
,
Factory Preset
(if
present).
2.
Connect the 10 MHz REF OUT from the rear panel to the
front-panel INPUT.
front-panel INPUT.
3.
Set the center frequency to 10 MHz by pressing
FREQUENCY
,
Center Freq
, 10,
MHz
.
4.
Set the span to 5 MHz by pressing
SPAN,
5,
MHz
.
5.
Set the resolution bandwidth to spectrum analyzer coupling by
pressing
pressing
BW/Avg
,
Res BW
(SA).
6.
Set the Y-Axis Units to dBm by pressing
AMPLITUDE
,
More,
Y-Axis Units,
dBm
.
7.
Set the reference level to 10 dBm by pressing
AMPLITUDE
,
Ref Level
,
10,
dBm
.
The 10 MHz reference signal appears on the display.
8.
Press
Peak Search
to place a marker on the peak.
9.
Press
Marker
→
,
Mkr
→
CF Step
to set the center frequency step size
equal to the frequency of the fundamental signal.