Chief Manufacturing MSP-DCCMD Manual De Usuario
I N S T A L L A T I O N I N S T R U C T I O N S
CHIEF MANUFACTURING INC.
1-800-582-6480 952-894-6280 FAX 952-894-6918
8401 EAGLE CREEK PARKWAY, STE 700
SAVAGE, MINNESOTA 55378 USA
8832-000088 Rev. C
©2006 Chief Manufacturing
www.chiefmfg.com
Printed in USA 03/06
BEFORE YOU BEGIN
Medium Flat Panel
Dual Swing Arm Wall Mount (JWD)
Model MSP-DCCMD
Dual Swing Arm Wall Mount (JWD)
Model MSP-DCCMD
The JWD single swing arm wall mount was designed for
mounting a medium sized flat panel display. The JWD
can swing out from the wall or fold against the wall,
depending on your ergonomic need. The mount itself can
be tilted +15º. The amount of tilt left and right depends on
the size and location of the display.
mounting a medium sized flat panel display. The JWD
can swing out from the wall or fold against the wall,
depending on your ergonomic need. The mount itself can
be tilted +15º. The amount of tilt left and right depends on
the size and location of the display.
The JWD is shipped with the VESA® 100mm/100mm
Centris™ interface which is compatible with most medium
flat panels. To accommodate the mounting hole patterns
on existing medium flat panels that are offered in different
sizes, the JWD is supplied with two interface adapters,
listed below:
Centris™ interface which is compatible with most medium
flat panels. To accommodate the mounting hole patterns
on existing medium flat panels that are offered in different
sizes, the JWD is supplied with two interface adapters,
listed below:
•
The 200mm/100mm interface adapter
•
The interface adapter that accomodates the
400mm/200mm and 550mm/235mm hole
patterns
The JWD will more than likely adapt to your medium flat
panel display, providing that your display does not exceed
the specified weight rating.
panel display, providing that your display does not exceed
the specified weight rating.
CAUTION: To prevent damage to the JWD, which could affect or void the Factory warranty, and to the equipment
that will be attached to it, thoroughly study all instructions and illustrations before you begin the installation. Pay
particular attention to the “Important Warnings and Cautions” on Page 2.
that will be attached to it, thoroughly study all instructions and illustrations before you begin the installation. Pay
particular attention to the “Important Warnings and Cautions” on Page 2.
•
The maximum weight to be installed on the JWD wall mount is 75 pounds (34 kg).
•
The JWD wall mount is designed to be installed using wall studs or supporting framework. The structure to which
the JWD wall mount is anchored must be capable of supporting five times the total weight of the mount and all
attached equipment.
•
If you have any questions about this installation, contact Chief Manufacturing at 1-800-582-6480.
•
If a defect is discovered after Dell’s initial 21-day Customer Satisfaction period, Chief Mfg. will, at its option,
repair or replace the product at no charge provided it is returned during the warranty period. Please note contact
information for Chief Mfg. listed below: