MSC Heart Rate Monitor Manual De Usuario
-3-
Magnet & Sensor
!
Use a coin to attach the wheel magnet
q
temporarily
to the right side spoke of front wheel.
Caution:
Attach the sensor and the magnet within
10cm from the hub axle.
@
Attach the speed sensor
2
temporarily to the right
front fork. Adjust the sensor
2
and the magnet
q
referring to the conditions A and B . After adjusting,
tighten the screw
tighten the screw
0
and the magnet
q
.
$
Attach the cadence magnet
w
to the crank. Adjust the
position of the sensor and the magnet referring to the
conditions A and B . After adjusting, fix the cadence
magnet
w
with the adhesive tape and the nylon tie
6
.
Bracket
Attach the bracket rubber pad with holder
9
to the bracket
1
and mount it to the handle bar.
Reference: If it does not fit well, use the rubber pad
8
.
Wire
%
Secure the wire along the frame using the nylon ties
6
and wind it round the brake cable up to the handlebar.
Caution:
Allow enough wire clearance in the area marked
with
with
.
Crank
Chain stay
#
Attach the cadence sensor
3
temporarily to the left
chain stay.
Reference:
If the clearance between
spoke and front fork is wider
than 5mm, mount the sensor
band
If the clearance between
spoke and front fork is wider
than 5mm, mount the sensor
band
3
and
4
in an opposite
way as shown.
Front fork
Spoke