Clifford G4102X Manual De Usuario

To enter turbo timer mode with a manual transmission:

Perform the manual transmission procedure (See p. 22) with the door open.

Transmit the timer mode feature with the remote by pressing

two-times, and

then press

A U

After exiting the vehicle, lock the system and the vehicle remains running for the

programmed runtime. (The remote start feature is still enabled).

You can still remote start the vehicle after the turbo timer has timed out and

shut Off the vehicle. For safety reasons, if a door is opened (while the system

is Locked or Unlocked) while you are away, the remote start exits the manual

transmission mode and will not remote start until the MTS sequence is re-

initiated.

Note: An optional push button can be hardwired to the (-) activation input

(H1/10) on the remote start module if you want to activate the turbo timer

without using the remote.

When the vehicle is running follow the procedures listed above, but instead

of pressing the remote, press the push button the appropriate number of times

to activate the remote start (factory setting is for 1 pulse). After which you can

turn Off the ignition and exit the vehicle. The car remains running for the pre-

programmed amount of time.

➤

Smart start activation

With Smart Start the remote start automatically activates when the vehicle

reaches a certain temperature, or when it reaches a certain voltage.

Note: This feature works only when the system has been locked with the

remote.

The factory setting for temperature high is 100º, and the low is 0º (F). The

voltage setting is 10.5v. These settings can be adjusted or turned off by your

installer using the Bitwriter.