Razor E150 Manual De Usuario

3

q 

WARNING: Failure 

to properly tighten the wedge 

may allow the handlebars to 

dislodge while riding and may 

cause you to lose control and 

fall. When correctly tightened, 

the handlebars will not rotate 

out of alignment with the 

front wheel under normal 

circumstances.

WARNING: Keep your 

fingers clear of the pivoting 

mechanism when folding or 

unfolding the scooter, and make 

sure others are standing clear.

Note: The cable and wire 

assembly from the handlebar 

must not wrap around the 

steering tube or handlebar 

as shown in step 3. Sharp 

bends or twisting of the brake 

cable can cause the brakes to 

malfunction.

q 

 

Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery 

prior to use. 

 

• Initial charge time: 12 hours 

•  Run time: up to 40 minutes 

• Recharge time: up to 8 hours, 

•  Average battery life: 250 charge/discharge cycles 

    Battery should be recharged

    a minimum of 8 hours after 

    each use. When the vehicle

    is not in regular use, recharge

    the battery at least once a

    month until normal use 

    is resumed.

  

 

Plug the charger port into the 

port on the scooter. The charger 

works with the power switch 

in either the on or off position. 

The charging input, on/off 

switch and overload breaker are 

located under the deck at the 

front left-hand side.

Plug the charger plug into a 

wall outlet.

WARNING:  Always 

disconnect your scooter from 

the charger before cleaning with 

liquid.

Note: If your charger does not 

look like the one illustrated, 

your unit has been supplied 

with an alternative charger. 

The specifications and charging 

procedure would not change.

The charger has a small window 

with one LED or two LEDs to 

indicate the charge status. 

Refer to the illustration on 

the charger unit for the actual 

“charging” and “charged” status 

indications for your model 

charger. 

Chargers have built-in over-

charge protection to prevent 

battery from being over-charged. 
Be sure to properly align the 

Charger 

Plug 

Charger 

Port

Using a 6mm hexagonal 

key wrench, tighten the 

wedge by turning the bolt 

clockwise. The wedge is 

properly tightened when the 

handlebars cannot be twisted 

out of alignment with the 

front wheel.

Pivot the handlebar assembly 

upright.

Loosen the locking knob 

and swing to the 6 o’clock po-

sition to unfold the handlebar.

Remove the plastic protector 

covering the base of the handle-

bar assembly. Insert the “quill” 

part of the handlebar assembly 

into the fork. You may have to 

loosen the wedge to allow it to 

slip into the fork.

Slide the quill into the 

fork until it bottoms on the 

headset.

Swing the locking knob to 

the 12 o’clock position and 

tighten by hand as firmly as 

possible.

WARNING:  Failure 

to recharge the battery at least 

once a month may result in 

a battery that will no longer 

accept a charge.