Wayne-Dalton 2411 Manual De Usuario
PG. 7
PG. 10
FOUR SPRINGS
(3-3/4” & 6”)
(6” Shown)
* NOTE: COUPLING USED ON SOLID SHAFT ONLY. TIGHTEN CONNECTING BOLTS AFTER WINDING SPRINGS.
RED WINDING CONES AND CABLE DRUMS WILL
ALWAYS BE ON THE LEFT
BLACK (OR PLAIN) WINDING CONES AND CABLE
DRUMS WILL ALWAYS BE ON THE RIGHT
LOOKING FROM THE INSIDE OF THE DOOR TO
THE OUTSIDE
RIGHT HAND DRUM
BLACK
EXTRA CENTER SUPPORT BRACKET USED WITH SPLIT SHAFT
WINDING CONE
BLACK
WINDING CONE
BLACK
WINDING CONE
RED
WINDING CONE
RED
3-1/2” for
3-3/4” SPRINGS
7” for
6” SPRINGS
LEFT HAND DRUM
RED
13”
8” MIN.
SPRING
PAD
12” MIN.
PAD
WIDTH
COUPLING (SEE NOTE * )
WINDING CONE
RED
13”
EXTRA CENTER SUPPORT BRACKET
USED WITH SPLIT SHAFT
COUPLING (SEE NOTE * )
RIGHT HAND DRUM
BLACK
WINDING CONE
BLACK
20”
24” MINIMUM SPRING PAD
WIDTH
LEFT HAND DRUM
RED
REVERSE MOUNTING
WHEN INSTALLING
3 3/4” SPRINGS
WHEN INSTALLING
3 3/4” SPRINGS
TWO SPRINGS
(3-3/4” & 6”)
SPLIT SHAFT
(6” Shown)
5/16” X 1” Self drilling
& tapping screw for use
on steel jambs.
3/8” X 3” Sleeve anchor for
use on pre-cast concrete.
( Drill a 3/8” x 3-1/2”
deep hole)
5/16” X 1 5/8” Lag
screw for use on
wood jambs.
Angle out
(wood jambs)
Reverse angle
(steel or precast/
block)
10”
NOTE: Typical
fastener spacing.
Install hardware onto left side
of section, install roller into
vertical track, rotate the
section into position and
stack, align sections and
secure right hand hardware.
Fig. L
Standard Strutting Schedule
(15.2 PSF)
30”or 18”
24”
24”
24”
Door Widths
Strutting
THRU 12' 2"
None
12' 3" - 16' 2"
(1) 2" U-Bar Per Section
2411 Strutting Schedule
Standard Section Reinforcement
Door Widths
Strutting
THRU 12' 2"
None
12' 3" - 16' 2"
(1) 2" U-Bar Per Section
16' 3" - 20' 2"
(1) 3" U-Bar Per Section
20' 3" - 24' 2"
(1) 6" Welded Truss Per Section
24' 3" - 26' 2"
(2) 6" Welded Truss Per Section
26' 3" - 32' 2"
(2) 8" Welded Truss Per Section
2415 Strutting Schedule
Standard Section Reinforcement