Chamberlain 459950 Manual De Usuario

Having a Problem? (Troubleshooting)

1. My door will not close and the light bulbs blink on

my motor unit: The safety reversing sensor must be
connected and aligned correctly before the garage door
opener will move in the down direction.

• Verify the Safety Reversing Sensors are properly

installed, aligned and free of any obstructions.
Refer to Installation Step 11: Install The Protector
System

• Check diagnostic LED for ﬂ ashes on the motor unit

then refer to the Diagnostic Chart on the following
page.

2. My remotes will not activate the door:

• Verify your Smart Control Panel

is not blinking. If

it is blinking, deactivate the Lock Mode following
the instructions for Using the Wall-Mounted Door
Control.

• Reprogram remotes following the programming

instructions. Refer to Programming.

• If remote will still not activate your door, check

diagnostic LED for ﬂ ashes on motor unit then refer
to Diagnostic Chart on the following page.

3. My door reverses for no apparent reason: Repeat

safety reverse test after adjustments to force or travel
limits. The need for occasional adjustment for the force
and limit settings is normal. Weather conditions in
particular can affect door travel.

• Manually check door for balance or any binding

problems.

•

Refer

Adjustment Step 2, Set the Force.

4. My door reverses for no apparent reason after fully

closing and touching the ﬂ oor: Repeat safety reverse
test after adjustments to force or travel limits. The
need for occasional adjustment for the force and limit
settings is normal. Weather conditions in particular can
affect door travel.

•

Refer

Adjustment Step 1, Program the Travel

Limits.

5. My lights will not turn off when door is open:

• The garage door opener is equipped with a security

light feature. This feature activates the light on
when the safety reversing sensor beam has been
obstructed. Refer to Operation section; Using the
Wall-Mounted Door Control, Light Feature.

6. My motor unit hums brieﬂ y:

• First verify that the trolley is against the stop bolt.

• Release the door from the opener by pulling the

Emergency Release Rope.

• Manually bring the door to a closed position.

• Loosen the belt by adjusting the outer nut 4 to 5

turns. This relieves the tension.

• Run the motor unit from the remote control or door

control. The trolley should travel towards the door
and stop. If the trolley re-engages with the door, pull
the Emergency Release Rope to disengage.

• Re-Tighten the outer nut until the trolley spring is

approximately 1-1/4" (3.18 cm) in length.

• If the trolley does not move away from the bolt,

repeat the steps above.

7. If battery status LED is not lit properly:

• Check battery connections.

8. My garage door opener beeps:

• A solid LED with beep, sounding approximately every

2 seconds, indicates the motor unit is activating the
door and is operating off of the battery

• A ﬂ ashing LED with beep, sounding every 30

seconds, indicates battery is low.

• If a red LED remains on when the power is restored,

and is accompanied by a beep sounding every 30
seconds, replace the battery.

Trolley

1-1/4"
(3.18 cm)

Diagnostics
Located On
Motor Unit

Sending Eye Safety Reversing
Sensor (Amber Indicator Light)

Receiving Eye Safety Reversing
Sensor (Green Indicator Light)

Bell Wire

Safety Reversing Sensor

“Learn”
Button
LED or

Diagnostic
LED