CFM Corporation A132 Manual De Usuario

11

1.  The use of substitute glass will void all product 

warranties.

2.  Care must be taken to avoid breakage of the glass.  
3.  Under no circumstances should this appliance be 

operated without glass properly installed, or with any 
cracked or broken glass. Replacement of any glass 
assembly as supplied by the manufacturer should be 
done by a licensed qualified service person.

1.

2.

Louvre

Glass 

Panel

FP444

Fig. 15  Louvre removal.

It will be necessary to clean the glass periodically. 
During start-up, condensation, which is normal, forms 
on the inside of the glass and causes lint, dust and 
other airborne particles to cling to the glass surface. 
Also initial paint curing may deposit a slight film on 
the glass. It is therefore recommended the glass 
be cleaned two or three times with a non-ammonia 
household cleaner and warm water (we recommend 
gas fireplace glass cleaner). After that the glass should 
be cleaned two or three times during each heating 
season depending on the circumstances present.

1.  Remove the top louvre. (Refer to “Louvre Removal” 

section)

2.  Open access door.
3.  Remove two (2) machine screws from the bottom of 

glass frame. (Fig. 16)

4.  Lift up and unhook glass frame at the top.

�������

�

��������������

������������

������������������

�������������

��������������������

���������������

To remove top flat lou-
vre pull louvre up and 
then lift out.

FP1373

RHE 

window frame

removal

6/03

Screws

Open Access Door

Machine Screws

Glass Frame

FP1373

Fig. 16  Remove glass frame.

Refer to Figures 17 & 18
1.  Remove front glass. (Refer to "Glass Removal" sec-

tion)

2.  Remove logs from packaging.
3.  Place left rear log (N15 or N17) by using the log’s 

bottom holes to locate it into the two pin studs lo-
cated on the left side of the rear log support.

4.  Place right rear log (N16 or N18) by using the log’s 

bottom holes to locate it into the two pin studs lo-
cated on the right side of the rear log support.

5.  Place front right log (N14 or N20) onto locator 

notches. Ensure the log is securely in place.

6.  A125: Place front left log (N13) onto locator. Ensure 

the log is securely in place.

  A132: Place front left log (N19) against the back of 

the left burner heat shield and the front edges of the 
log should be flat against the front deflector.

7.  Place ember material on to the front area of the 

burner.