Heat & Glo LifeStyle 2137-900 Manual De Usuario

Heat & Glo  •  Soho24B  •  2137-900 Rev. P  •  8/12

4

14,000

N/A

50

12,600

N/A

51

13,000

N/A

59

11,700

N/A

60

MODELS:   Soho24B

LABORATORY:   Underwriters Laboratories, Inc. (UL)

TYPE: Direct Vent Gas Appliance Heater

STANDARD: ANSI Z21.88a-2007 • CSA2.33a-2007 

Hearth & Home Technologies appliances manufactured with 
tempered glass may be installed in hazardous locations such 
as bathtub enclosures as defi ned by the Consumer Product 
Safety Commission (CPSC). The tempered glass has been 
tested and certifi ed to the requirements of ANSI Z97.1 and 
CPSC 16 CFR 1202 (Safety Glazing Certifi cation  Council 
SGCC# 1595 and 1597. Architectural Testing, Inc. Reports 
02-31919.01 and 02-31917.01).

This statement is in compliance with CPSC 16 CFR Section 
1201.5 “Certifi cation and labeling requirements” which refers 
to 15 U.S. Code (USC) 2063 stating “…Such certifi cate shall 
accompany the product or shall otherwise be furnished to 
any distributor or retailer to whom the product is delivered.”

Some local building codes require the use of tempered glass 
with permanent marking in such locations. Glass meeting 
this requirement is available from the factory. Please contact 
your dealer or distributor to order.

Note:  This installation must conform with local codes. In the 
absence of local codes you must comply with the National 
Fuel Gas Code, ANSI Z223.1-latest edition in the U.S.A. and 
the CAN/CGA B149 Installation Codes in Canada.

Do NOT use this appliance if any part has been under water. 
Immediately call a qualifi ed service technician to inspect the 
appliance and to replace any part of the control system and 
any gas control which has been under water.

This product is listed to ANSI standards for “Vented Gas 
Appliance Heaters” and applicable sections of “Gas 
Burning Heating Appliances for Manufactured Homes 
and Recreational Vehicles”, and “Gas Fired Appliances 
for Use at High Altitudes”.

Material which will not ignite and burn. Such materials are 

those consisting entirely of steel, iron, brick, tile, concrete, 
slate, glass or plasters, or any combination thereof.

Materials that are reported as passing ASTM E 136, 

Standard Test Method for Behavior of Materials in a 
Vertical Tube Furnace at 750ºC, shall be considered 
non-combustible materials.

Materials made of or surfaced with wood, compressed 
paper, plant fi bers, plastics, or other material that can 
ignite and burn, whether fl ame proofed or not, or whether 
plastered or unplastered shall be considered combustible 
materials.

NOTICE:  This appliance must be electrically wired and 
grounded in accordance with local codes or, in the absence 
of local codes, with National Electric Code ANSI/NFPA 
70-latest edition or the Canadian Electric Code CSA 
C22.1.

•  A 110-120 VAC circuit for this product must be protected 

with ground-fault circuit-interrupter protection, in compliance 
with the applicable electrical codes, when it is installed in 
locations such as in bathrooms or near sinks.

NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.  
This appliance is tested and approved as either supplemen-
tal room heat or as a decorative appliance.  It should not be 
factored as primary heat in residential heating calculations.

U.L. Listed gas appliances are tested and approved without 
requiring changes for elevations from 0 to 2000 feet in the 
U.S.A. and Canada.

When installing this appliance at an elevation above 2000 
feet, it may be necessary to decrease the input rating by 
changing the existing burner orifi ce to a smaller size. Input 
rate should be reduced by 4% for each 1000 feet above 
a 2000 foot elevation in the U.S.A., or 10% for elevations 
between 2000 and 4500 feet in Canada. If the heating value 
of the gas has been reduced, these rules do not apply. To 
identify the proper orifi ce size, check with the local gas utility.

If installing this appliance at an elevation above 4500 feet (in 
Canada), check with local authorities.