Hearth & Home Technologies CL36D Manual De Usuario

12538 Rev D

02-02

CL36D AND CR36D INSTALLATION INSTRUCTIONS

Figure 3

Installation Along a Wall or an Exterior Chase

WARNING!

Do not draw outside air from garage spaces. Exhaust products of gasoline engines are hazardous.
Do not install outside air ducts such that the air may be drawn from attic spaces, basements or above the

roofing where other heating appliances or fans and chimneys exhaust or utilize air. These precautions will

reduce the possibility of fireplace smoking or air flow reversal.

WARNING!

To prevent contact with sagging or loose insulation, the fireplace must not be installed against vapor barriers

or exposed insulation. Localized overheating could occur and a fire could result.

These are rough framing

dimensions only.

Figure 2 - Fireplace Locations

1. Fireplace Locations and Space Requirements

Several options are available to you when choosing a location for your fireplace. This fireplace may be used as a

room divider, installed along a wall, across a corner or used in an exterior chase. See Figure 2.
Locating the fireplace in a basement, near frequently opened doors, central heat outlets or returns, or other locations

of considerable air movement can affect the performance and cause intermittent smoke spillage from the front of

the fireplace. Consideration should be given to these factors before deciding on a location.

CLEARANCES!

A minimum ½ air clearance

must be maintained at the

back and side of the fireplace

assembly.
Chimney sections at any level

require a 2 minimum air

space clearance between the

framing and chimney section.

D. PRE-INSTALLATION PREPARATION

Figure 3 shows a typical installations assuming an outside air kit is being used. Therefore, an allowance must be

made for 90° bends. Less space is required when ducting goes directly outside without forming elbows.