FMI (V)DVF42PH Manual De Usuario
www.fmiproducts.com
125078-01B
22
OPerAtiOn
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance is equipped with an igni-
tion device which automatically lights
the pilot. Do not light pilot by hand.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
C. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation
of new fireplace, burning logs
will give off a paper-burning
smell. Orange flame will also
be present. Open damper or
window to vent smell. This will
only last a few hours.
1. STOP! Read the safety information in
column 1.
2. Turn off all electric power to fireplace.
3. Turn safety shutoff switch to the OFF
3. Turn safety shutoff switch to the OFF
position.
4. Remove center brick/control cover.
Figure 32 - Installing Battery in Hand-Held Remote Control Unit
(use only alkaline batteries, not included)
AAA
Batteries
Battery
Housing
Battery Cover
Remote
Control
Unit
Installing Batteries in Hand-Held Remote
Control Unit
1. Remove battery cover on back of remote
control unit.
FirePLAce inStALLAtiOn
Continued
2. Install 3 AAA batteries as instructed in
battery housing.
3. Replace battery cover onto remote control unit.