Friedrich XQ10 Manual De Usuario

5

To set the timer

NOTE: You can set the START and STOP times a minimum of one hour 
apart, and a maximum of 23 hours apart.

9

  TIMER START - Press Start to view the current start time for cooling.  

Continue pressing the Start button until you arrive at the start time 
you desire.  The start time for cooling will then be set.

10

  TIMER STOP - Press the Stop button. Continue pressing the Stop 

button until you arrive at the stop time you desire. The stop time for 
cooling will then be set.

11

  TIMER ON / OFF - Press the On/Off  button to activate (light on) or 

deactivate (light off) the timer.  Once the on and off times have been 
selected, they will remain in memory and cycle daily until changed.

NOTE: If the unit is unplugged or the power is interrupted, the Set Hr. 
function must be reset or the On/Off  function will not work.

How to use the remote control

To start unit

1

  POWER - Press the Power button once. The unit will automatically 

start in the mode and fan speed it was last left on.

To set mode of operation

2

  COOL - Press the Cool button to automatically switch the operating 

mode to COOL.

3

  FAN ONLY - Press the Fan Only button if you want to run the fan 

only.

4

  MoneySaver

  - Press the MoneySaver

  button to activate the 

MoneySaver

®

 feature. This feature cycles the fan with the compres-

sor so that the fan does not run all the time.

To adjust temperature setting

5

  WARMER - Press the   Warmer  button to raise the temperature 

setting.

6

  COOLER -  Press the    Cooler button to lower the temperature 

setting. 

To adjust fan speed

7

  FAN SPEED - Press the Fan Speed button to see the current set-

ting.  Press again to change the fan speed.  F1 is the lowest setting 

(SLEEP / LOW), F2 is MEDIUM, F3 is HIGH, and SF is the SMART 

FAN setting.

To set the hour clock

8

  SET HOUR CLOCK -  Press Set Hr. once to see the current clock 

setting. Continue pressing the button until you arrive at the current 
time (Hour only). Minutes are not shown on the display. Make sure 
that the A.M. / P.M. setting is correct.

 Start

8

10

7

11

9

4

3

1

2

5

6

!

How to operate your Friedrich room air conditioner 

(YQ07 / EQ08 models)

Model YQ07

This model is designed for use in warmer climates; therefore it does not have 

back-up electric heat and will not provide adequate heating below an outdoor 
ambient temperature of 37°F (3° C).

Function control

The left knob is a six position control that allows you to select heat or cool in 

either low speed or high speed. Plus you can select fan only if you wish.

Temperature control

The right hand knob is the thermostat - turn it clock wise for cool er, counter-

clock wise for warm er (See Figure 5).