Friedrich SQ05N10 Manual De Usuario

‹

  Inspect and ensure that all components and accessories have been 

installed properly and that they have not been damaged during the 

installation progress.

‹

  Check the condensate water drain(s) to ensure that they are adequate 

for the removal of condensate water, and that they meet the approval 

of the end user.

‹

  Ensure that all installation instructions concerning clearances around 

the unit have been adhered to. Check to ensure that the unit air ¿ lter, 

indoor coil, and outdoor coil are free from any obstructions.

‹

  Ensure that the circuit breaker(s) or fuse(s) and supply circuit wire 

size have been sized correctly. If the unit was supplied with a power 

supply cord, insure that it is stored properly.

‹

  Ensure that the entire installation is in compliance with all applicable 

national and local codes and ordinances having jurisdiction.

‹

  Secure  components  and  accessories,  such  as  a  decorative  front 

cover.

‹

  Start the unit and check for proper operation of all components in 

each mode of operation.

‹

  Instruct the owner or operator of the units operation, and the 

manufacturer's Routine Maintenance.

NOTE:  A log for recording the dates of maintenance and/or service is 

recommended.

‹

  Present the owner or operator of the equipment with the Installation 

& Operation Manual, all accessory installation instructions, and the 

name, address and telephone number of the Authorized Friedrich 

Warranty Service Company in the area for future reference if 

necessary. 

Your air conditioner is designed to cool in warm weather when the outside 

temperature is above 60°F (15.6°C) and below 115°F (46.1°C), so it won't 

cool a room if it is already cool outside.

Air conditioners actually pump the heat and humidity from your room to the 

outside. Humidity becomes water, and your air conditioner will use most 

of the water to keep the outside coil cool. If there is excessive humidity, 

there may be excess water that will drip outside. This is normal operation.

This usually occurs because of insuf¿ cient airÀ ow across the coils, a dirty 

¿ lter, cool damp weather, or all of these. Set the SYSTEM mode to FAN 

ONLY   and the frost will disappear. Setting the thermostat a little warmer 

will probably prevent the frosting from recurring.

All air conditioners make some noise. Friedrich units are designed to 

operate as quietly as possible. An air conditioner mounted in a wall is quieter 

than one mounted in a window. It is important to ensure that the chassis 

seal gasket (Item 14) is properly installed (refer to installation instructions).

41