New Buck Corporation 94NC Manual De Usuario
8. Obtain outer trim kit provided with insert kit and slip over top and sides of trim panels.(See Figure 7). (Top
ends of outer trim may need to be trimmed to fit).
9. Using insulation provided, peel and stick to back of panels overlapping fireplace dimensions by 1" on each
side and top. (See Figure 8).
10. Next using high heat silicone or furnace cement run heavy bead of caulking around where back of panels meet
stove. (See Figure 8).
11. Slide unit back into fireplace. Check to be sure that trim panels (and outer trim) are properly positioned and
lie flat against front of fireplace. If panels are out of position, slide unit out and reset by loosening mounting
screws and repositioning in slot. With bar lift stove up in front. Place insulation across front at bottom and
surface of hearth or bottom of fireplace to make complete seal.
screws and repositioning in slot. With bar lift stove up in front. Place insulation across front at bottom and
surface of hearth or bottom of fireplace to make complete seal.
12. To check seal of panels, use candle flame and go around entire area sealed by silicone and insulation. If flame
leans toward inside of fireplace, add additional insulation. This ensures an airtight seal.
FINAL CHECK
1. Recheck specified clearances.
2. Remove all foreign material from firebox area.
3. Open primary air control.
Primary Air Control: The primary air intake draft control is located at right bottom side of hearth. It is
operated by moving handle out to open (to allow air into firebox) or in (to control or close off) air into
firebox. (See Figure 7).
operated by moving handle out to open (to allow air into firebox) or in (to control or close off) air into
firebox. (See Figure 7).
4. Plug power cord into a 115V AC outlet. “Do not run cord under unit or in high traffic areas.
5. Place crumpled pieces of newspaper in stove. Light it and close door. Ensure that stove draws properly
through primary draft.
NOTE: “Do not use grate or elevate fire. Build wood fire directly on fire box bottom.”
6. Check for smoke leaks around door.
7. Open door and check for smoke escaping from front of stove. Smoking usually indicates a defective or poorly
positioned chimney. Some chimneys with a marginal draft can be pre-heated by lighting newspaper and
holding it near open damper with a poker or fire tong. Once chimney heats up, a proper draft can usually be
obtained.
holding it near open damper with a poker or fire tong. Once chimney heats up, a proper draft can usually be
obtained.
If a thorough review of Troubleshooting Guide in rear of manual does not reveal
problem, contact your dealer for assistance
.
INSULATION
FIGURE 8
Buck
Stove
FIGURE 7
Primary Air Control
Top Trim Panel
Side Trim Panel
Outer Trim
Page 9