Runco SC-35d Manual De Usuario
Runco SC-30d/SC-35d Installation/Operation Manual
39
PRE
L
IMINAR
Y
Additional Connections to
the Dimension Digital
Controller (Optional)
the Dimension Digital
Controller (Optional)
The Dimension Digital Controller provides the following interfaces to external equipment
that allow it to control or be controlled by that equipment:
that allow it to control or be controlled by that equipment:
• An RS-232 interface to a PC or control/automation system;
• Three (3), 12-volt trigger outputs;
• An infrared (IR) repeater input;
• An Ethernet network interface for serial command control (via Telnet), firmware updates
and maintenance notifications.
The following sections describe how to make these interface connections.
RS-232 Controller Connection: Use a straight-through, 9-pin RS-232 cable to connect
a PC or control/automation system (if present) to the RS-232 port on the Dimension
Digital Controller; see Figure 3-15.
a PC or control/automation system (if present) to the RS-232 port on the Dimension
Digital Controller; see Figure 3-15.
Figure 3-15. RS-232 Control System Connection to Dimension Digital Controller
PC / Control
RS-232
IR
Pri. Display Control
Sec. Display Control
HDMI 5
HDMI 6
HDMI 7
HDMI 8
Ethernet
HDMI Out
To Sec. Display
HDMI Out
To Pri. Display
HDMI Out
Audio Only
IR
Pri. Display Control
Sec. Display Control
HDMI 5
HDMI 6
HDMI 7
HDMI 8
Ethernet
HDMI Out
To Sec. Display
HDMI Out
To Pri. Display
HDMI Out
Audio Only
1
2
3
4
5
7
8
9
6
to Automation/
Control System
or PC
2 Receive Data
(to ctrl. system)
3 Transmit Data
(from ctrl. system)
5 Ground
(none of the other pins are used)